Skip to content
ScugogGarage Door Co. · SeagraveOpen 24/7(289) 653-1434Request a visit
Gloved person holding a black strip along the side of a sectional garage-door opening — Garage Door Perimeter Weatherstrip, Seagrave

Repairs · Seagrave

Garage Door Perimeter Weatherstrip in Seagrave

Every time the door closes there is a rubbing squeal along one side, and the flexible fin has folded under itself and torn. Someone painted the trim last summer and painted the seal with it; now it is stiff as a board.

Garage Door Perimeter Weatherstrip

In plain words

For an attached garage the perimeter seal does more than keep leaves out. The garage is a buffer between the weather and the house, and drafts around the door cool the wall it shares with the kitchen and the floor of the room above it. Snow blown in melts and refreezes on the slab, and mice follow the warm air in at open corners. A well-fitted side and header seal closes those paths and eases the job of the weatherstripped door between garage and house, though the garage's warmth also depends on the door's own seal, the ceiling and the heating. It is a worthwhile comfort improvement for the house.

Sound familiar?

The new door went in last year and looks perfect, but the old wooden stop and its tired seal were left in place. Along the top there is a gap you could slide a finger into, and the cold pours through it.

How the visit goes

Seagrave

How the visit goes

  1. How the door sits in the opening

    A perimeter seal can only follow a door that sits where the frame expects it, so the door is checked before any strip is ordered or cut. Each edge is checked for plumb, the gap to both jambs is compared, and the top section is watched as it meets the header to see whether it bows away or leans in. Rollers, hinges and the spacing of the vertical tracks are looked at because any of them can shift the door face toward one jamb and away from the other. Small corrections, such as re-setting a track bracket, are noted so the new seal is fitted to a door that closes square and stays that way.

  2. Replacing the wood stop with a one-piece vinyl stop

    When the old wood stop is cracked, rotten or buried in paint, it is replaced rather than covered. The one-piece stop, a rigid vinyl moulding with the flexible fin formed along one edge, is cut on a mitre saw to header and side lengths and fitted the same way, header first. It needs no paint, does not rot, and its fin and stop are one part, so the seal cannot peel away from the moulding. Corners are either mitred or the sides butted tight under the header with the fins overlapped. The result looks like fresh trim and works as a seal.

  3. Keep paint off the fin

    When the trim is next painted, the flexible fin stays bare. Paint fills the flexible material and stiffens it, and a stiff fin cracks well before its time once the cold takes hold. If the rigid part of the stop is wood, it can be painted, but with the brush kept off the fin or the fin masked. One-piece vinyl stop needs no paint at all and simply washes clean. This single habit is the difference between a seal that stays soft for many years and one that fails early, and it is the most common cause of early failure the technician sees.

Garage Door Perimeter Weatherstrip

In the van

  • Galvanized or stainless trim nails
  • Flexible vinyl fin seal
  • Tape measure, level and square
  • Epoxy consolidant and exterior primer
  • Vinyl stop moulding with integral seal

What affects the quote

Same fees day, night or weekend

  1. 1Colour and profile

    Standard colours and fin widths are carried on the truck. A less common colour, an extra-wide fin or a commercial retainer with insert may be a special order, with the difference noted.

  2. 2Number of doors

    Two or three doors on the same property share the set-up time and are quoted together, usually at less per opening than a single door on its own.

  3. 3Doing the bottom seal at the same time

    When the bottom seal on the door is also worn, renewing it during the same visit is offered as a separate line and saves the cost of a second call.

What to have ready

0 of 3 ready

Call (289) 653-1434

Garage Door Perimeter Weatherstrip: questions

My door was replaced last year. Does the perimeter seal need doing too?

Often, yes. A new door is sometimes fitted against the original wood stop and its old fin, and the new door may sit slightly differently in the opening, so the old seal no longer meets it. If daylight shows at the edges or the fin is hard and cracked, a new seal set against the new door completes the installation and matches the fresh look of the door.

Will a new seal make the room above my garage warmer?

It can help. Drafts around the garage door cool the garage, and the garage cools the floor above it and the wall it shares with the house. Closing the perimeter cuts those drafts, though how much warmer the garage runs depends on the door's own seal, the ceiling insulation and how the space is heated, not the perimeter alone. A technician can talk through those as separate steps if the room stays cold.

How long does the visit take?

A straightforward fin replacement on a single door is often a matter of an hour or two once the technician is set up; a double door with a one-piece stop takes longer, and any jamb repair adds to it. Most of the time goes into checking the door, preparing the surface and setting the contact carefully, since those are what make the seal last. You are given a sense of the timing when the work is confirmed.

Repair & Maintenance

Garage Door Perimeter Weatherstrip near you

For homes and businesses in Seagrave we handle the full run of garage door work: broken springs and cables, doors that have left the track, openers and remotes that stopped answering, worn rollers and seals, tune-ups, and new doors chosen and installed to suit the building.

Open 24/7 · call(289) 653-1434Request a visit